| NORTHROP GRUMMAN SYSTEMS CORPORATION | 26916 |
| NIMIKKEISTOKESKUS NCB FINLAND | A486G |
| BOEING COMPANY, THE | 94756 |
| MARATHONNORCO AEROSPACE, INC. | 74025 |
| NAVAL SEA SYSTEMS COMMAND | 53711 |
| RAYTHEON COMPANY | 5869 |
| INDUSTRIAL ELECTRONIC ENGINEERS, INC. | 5464 |
| E.C.A ETABLISSEMENT CENTRAL DESAPPROVISIONNEMENTS DES FORCES ARMEE | A00AM |
| THALES DEFENSE & SECURITY, INC. | 65597 |
| PILATUS AIRCRAFT LTD | S4080 |
| NORTHROP GRUMMAN SYSTEMS CORPORATION | 6481 |
| AERONAUTICAL STANDARDS GROUP DEPT OF NAVY AND AIR FORCE | 88044 |
| NATIONAL AEROSPACE STANDARDS COMMITTEE AEROSPACE INDUSTRIES ASSOCIATION OF AMERICA INC NOT FOR RFQ OR SOLICITATION USE | 80205 |
| AIR FORCE-NAVY AERONAUTICAL SPECIFICATIONS PROMULGATED BY AERONAUTICAL STANDARDS GROUP | 81352 |
| AERONAUTICAL STANDARDS GROUP DEPT OF NAVY AND AIR FORCE | 88044 |
| MILITARY STANDARDS PROMULGATED BY MILITARY DEPARTMENTS UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | 96906 |
| MBDA UK LTD | K0967 |
| GENERAL MICROWAVE CORPORATION | 11332 |
| KONTRON AG | C1834 |
| CROSS-SECTIONAL SHAPE STYLE | 1 RECTANGULAR |
| HOLE DIAMETER | 0.125 INCHES NOMINAL |
| PERIPHERAL SHAPE STYLE | 1 ROUND |
| CENTER HOLE SHAPE STYLE | 1 ROUND |
| THICKNESS | 0.016 INCHES MINIMUM AND 0.035 INCHES MAXIMUM |
| OVERALL DIAMETER | 0.307 INCHES MINIMUM AND 0.332 INCHES MAXIMUM |
| MATERIAL | STEEL COMP 303S OVERALL |
| MATERIAL | STEEL CORROSION RESISTING OVERALL |
| MATERIAL DOCUMENT AND CLASSIFICATION | MIL-S-5059 MIL SPEC SINGLE MATERIAL RESPONSE OVERALL OR MIL-S-6721 MIL SPEC SINGLE MATERIAL RESPONSE |
| PROPRIETARY CHARACTERISTICS | PACS |
| A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch ( .8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be . 6 inches ( .15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be . 16 inches ( .4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items. |
