Part Number: 03858 1-2IN

(No reviews yet) Write a Review
CONDITION:
NS
WILLIAM POWELL COMPANY THE DBA POWELL VALVE DIV THE STARFLO CORPORATION48422
ZF INDUSTRIEANTRIEBE WITTEN GMBHD9182
ELECTRIC BOAT CORPORATION96169
WILLIAM POWELL COMPANY THE DBA POWELL VALVE DIV THE STARFLO CORPORATION48422
WILLIAM POWELL COMPANY THE DBA POWELL VALVE DIV THE STARFLO CORPORATION48422
ZF INDUSTRIEANTRIEBE WITTEN GMBHD9182
WILLIAM POWELL COMPANY THE DBA POWELL VALVE DIV THE STARFLO CORPORATION48422
ZF INDUSTRIEANTRIEBE WITTEN GMBHD9182
CROSS-SECTIONAL SHAPE STYLERECTANGULAR
HOLE DIAMETER1.125 INCHES NOMINAL
PERIPHERAL SHAPE STYLEROUND
CENTER HOLE SHAPE STYLEROUND
THICKNESS0.063 INCHES NOMINAL
OVERALL DIAMETER1.500 INCHES NOMINAL
III MINIMUM TENSILE STRENGTH2000 POUNDS PER SQUARE INCH
MATERIALASBESTOS OVERALL
MATERIAL DOCUMENT AND CLASSIFICATIONMIL-G-12803 NO. +1161-A MIL SPEC SINGLE MATERIAL RESPONSE OVERALL
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch ( .8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be . 6 inches ( .15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be . 16 inches ( .4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.