Part Number: 095-10700

(No reviews yet) Write a Review
CONDITION:
NS
PARKER-HANNIFIN CORPORATION33269
EATON AVIATION CORPORATION8118
OSHKOSH CORPORATION45152
OSHKOSH DEFENSE, LLC75Q65
EMBRAER S.A. DBA EMBRAER001JK
EMBRAER EMPRESA BRASILEIRA DE AERONAUTICA SAS4956
ESW GMBHD3683
PIPER AIRCRAFT INC.77294
RAYTHEON COMPANY96214
E.C.A ETABLISSEMENT CENTRALD'APPROVISIONNEMENT DES FORCES ARMEESCY13
KIDDE-FENWAL, INC.0KDP7
U S ARMY AVIATION AND MISSILE COMMAND18876
HONEYWELL INTERNATIONAL INC.6848
J. T. D. STAMPING CO., INC.6R888
AERONAUTICAL STANDARDS GROUP DEPT OF NAVY AND AIR FORCE88044
ZF INDUSTRIEANTRIEBE WITTEN GMBHD9182
ZF INDUSTRIEANTRIEBE WITTEN GMBHD9182
SOCATAF0086
CROSS-SECTIONAL SHAPE STYLERECTANGULAR
HOLE DIAMETER0.318 INCHES MINIMUM AND 0.338 INCHES MAXIMUM
PERIPHERAL SHAPE STYLEROUND
CENTER HOLE SHAPE STYLEROUND
THICKNESS0.022 INCHES MINIMUM AND 0.042 INCHES MAXIMUM
OVERALL DIAMETER0.557 INCHES MINIMUM AND 0.582 INCHES MAXIMUM
MATERIALSTEEL OVERALL
MATERIAL DOCUMENT AND CLASSIFICATIONMIL-S-7952 MIL SPEC SINGLE MATERIAL RESPONSE OVERALL OR QQ-S-698 FED SPEC SINGLE MATERIAL RESPONSE OVERALL
SURFACE TREATMENTCADMIUM OVERALL
SURFACE TREATMENT DOCUMENT AND CLASSIFICATIONQQ-P-416,TY 2,CL 3 FED SPEC SINGLE TREATMENT RESPONSE OVERALL
NONDEFINITIVE SPEC/STD DATAA TYPE AND 2 GRADE AND A CLASS
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch ( .8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be . 6 inches ( .15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be . 16 inches ( .4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.