Part Number: 1002-0008-001

(No reviews yet) Write a Review
CONDITION:
NS
CARLETON TECHNOLOGIES INC4577
CARLETON TECHNOLOGIES INC DIV TAMPA FACILITY1W506
NAVAL INVENTORY CONTROL POINT MECHANICSBURG3950
CARLETON TECHNOLOGIES INC4577
CARLETON TECHNOLOGIES INC DIV TAMPA FACILITY1W506
NAVAL INVENTORY CONTROL POINT MECHANICSBURG3950
CROSS-SECTIONAL SHAPE STYLERECTANGULAR
HOLE DIAMETER0.280 INCHES NOMINAL
PERIPHERAL SHAPE STYLEROUND
CENTER HOLE SHAPE STYLEROUND
OVERALL DIAMETER0.500 INCHES NOMINAL
III END ITEM IDENTIFICATIONVALVE ANL .50IPS
MATERIALPLASTIC POLYTETRAFLUOROETHYLENE OVERALL
SPECIAL FEATURESTERMINAL SURFACE TREATMENT GOLD PLATED
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch ( .8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be . 6 inches ( .15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be . 16 inches ( .4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.