Part Number: 11-5016-3

(No reviews yet) Write a Review
CONDITION:
NS
DRS POWER & CONTROL TECHNOLOGIES, INC.27192
PROMPTUS ELECTONIC HARDWARE INC57177
PROMPTUS ELECTONIC HARDWARE INC57177
MATTHEW WARREN, INC55566
DRS POWER & CONTROL TECHNOLOGIES, INC.27192
DEFENSE LOGISTICS AGENCY DBA DEFENSE SUPPLY CENTER PHILADELPHIA14153
THREAD CLASS2A
THREAD DIRECTIONRIGHT-HAND
THREAD LENGTH0.208 INCHES MINIMUM AND 0.228 INCHES MAXIMUM
FASTENER LENGTH0.610 INCHES MINIMUM AND 0.640 INCHES MAXIMUM
HEAD STYLEPAN NO. 2
HEAD DIAMETER0.213 INCHES MINIMUM AND 0.228 INCHES MAXIMUM
HEAD HEIGHT0.127 INCHES MINIMUM AND 0.132 INCHES MAXIMUM
FIRST DIAMETER FROM HEAD0.090 INCHES MINIMUM AND 0.100 INCHES MAXIMUM
DISTANCE FROM LARGEST BEARING SURFACE OF HEAD TO END OF FIRST DIAMETER0.396 INCHES MINIMUM AND 0.416 INCHES MAXIMUM
INTERNAL DRIVE STYLESLOT
NOMINAL THREAD DIAMETER0.138 INCHES
THREAD QUANTITY PER INCH32
CRITICALITY CODE JUSTIFICATIONZZZY
EXTERNALLY RELIEVED BODY DIAMETER QUANTITY1
MATERIALSTEEL COMP 303 OVERALL
MATERIAL DOCUMENT AND CLASSIFICATIONQQ-S-764 FED SPEC SINGLE MATERIAL RESPONSE OVERALL
SURFACE TREATMENTPASSIVATE OVERALL
SPECIAL TEST FEATURESSPECIAL QUALITY CONTROL TESTING
TEST DATA DOCUMENT81349-MIL-P-23199 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.).
THREAD SERIES DESIGNATORUNC
DEPARTURE FROM CITED DOCUMENTAS MODIFIED BY MATERIAL
REFERENCE NUMBER DIFFERENTIATING CHARACTERISTICSAS DIFFERENTIATED BY MATERIAL WHICH MUST CONFORM TO SHIPS PARTS CONTROL CENTER SPECIAL QUALITY CONTROL PROVISIONS
An externally threaded fastener whose threaded portion is of one nominal diameter, and whose unthreaded portion has been machined or ground in one or more places or over its entire length to a maximum diameter less than the minimum pitch diameter of the thread (excludes undercut for thread relief). It is No. ( . 6 IN.) (1.5 mm) or larger, and is designed to be held or driven with either a wrench or inserted driver (excluding internal socket and multiple spline types) or both in sizes below No. 1 ( .19 IN.) (5 mm) and larger sizes must have a head designed for any type inserted driver (excluding internal socket and multiple spline types) but may also be designed for external wrenching. A locking feature may be incorporated in the design of the head or threads. See also BOLT, EXTERNALLY RELIEVED BODY and BOLT, INTERNAL WRENCHING.