Part Number: 204-075-365-007

(No reviews yet) Write a Review
CONDITION:
NS
BELL HELICOPTER TEXTRON INC.97499
BELL HELICOPTER TEXTRON INC.97499
AERONAUTICAL STANDARDS GROUP DEPT OF NAVY AND AIR FORCE88044
MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M81349
SECTION QUANTITY1
BODY STYLECYLINDRICAL BUSHING MOUNTED
RELIABILITY INDICATORNOT ESTABLISHED
FIRST FLAT LENGTH0.500 INCHES NOMINAL
FLAT HEIGHT0.216 INCHES NOMINAL
BODY DIAMETER2.750 INCHES MAXIMUM
SHAFT DIAMETER0.250 INCHES NOMINAL
SHAFT LENGTH1.000 INCHES NOMINAL
MOUNTING BUSHING LENGTH0.375 INCHES NOMINAL
BODY LENGTH1.750 INCHES MAXIMUM
SHAFT STYLEROUND, FLATTED
CONTACT ARM ELECTRICAL OFF POSITIONFULLY CCW
ACTUATOR TYPESINGLE SHAFT
NONTURN DEVICE LOCATIONAT 12 OCLOCK
NONTURN DEVICE RADIUS0.500 INCHES NOMINAL
SCREW THREAD DIAMETER0.375 INCHES NOMINAL
SCREW THREAD SERIES DESIGNATORUNEF
SCREW THREAD QUANTITY PER INCH32
TERMINAL LOCATIONREAR END
MOUNTING METHODSTANDARD BUSHING
ELECTRICAL RESISTANCE PER SECTION25.0 OHMS SINGLE SECTION
POWER DISSIPATION RATING PER SECTION IN WATTS50.0 FREE AIR SINGLE SECTION
RESISTANCE TOLERANCE PER SECTION IN PERCENT-10.0 TO 10.0 SINGLE SECTION
TEST DATA DOCUMENT81349-MIL-R-6749 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.).
TERMINAL TYPE AND QUANTITY3 THREADED STUD
SPECIFICATION/STANDARD DATA81349-MIL-R-6749 GOVERNMENT SPECIFICATION
PRECIOUS MATERIALSILVER
A resistor in which a sliding or rolling contact moves over an exposed area of the resistive element to change the ohmic value of the output. The functional tolerance (linearity), if given, of the output is greater than plus of minus 1 percent on linear outputs. Specified outputs such as sine, cosine, tangent, etc., shall be considered to be precision. For items having manually positioned taps designed to be set and fixed prior to use, see RESISTOR, ADJUSTABLE. For items with step by step variation, see RHEOSTAT and RESISTOR, STEP BY STEP. For tandem-mounted items designed to function together as an attenuator (and rated accordingly), see ATTENUATOR, VARIABLE. Excludes RESISTOR (1), VARIABLE, NONWIRE WOUND, NONPRECISION; RESISTOR (1), VARIABLE, NONWIRE WOUND, PRECISION; and RESISTOR (1), VARIABLE, WIRE WOUND, PRECISION.