GENERAL MOTORS CORP | 24617 |
AM GENERAL LLC | 34623 |
GENERAL MOTORS LLC | 7X677 |
NCB HUNGARY HONVEDSEGI EGYSEGES TERMEKKOD | 0000V |
INSPEKTORAT WSPARCIA SIL ZBROJNYCH | 9009H |
INSPEKTORAT WSPARCIA SIL ZBROJNYCH | 9009H |
AMERICAN SOCIETY OF MECHANICAL ENGINEERS | 5047 |
AM GENERAL LLC | 34623 |
CROSS-SECTIONAL SHAPE STYLE | RECTANGULAR |
HOLE DIAMETER | 0.281 INCHES NOMINAL |
PERIPHERAL SHAPE STYLE | ROUND |
CENTER HOLE SHAPE STYLE | ROUND |
THICKNESS | 0.067 INCHES NOMINAL |
OVERALL DIAMETER | 0.500 INCHES NOMINAL |
III END ITEM IDENTIFICATION | MRAP - COUGAR TOW |
FEATURES PROVIDED | CASEHARDENED |
MATERIAL | STEEL OVERALL |
SURFACE TREATMENT | ZINC AND DICHROMATE OVERALL |
CROSS-SECTIONAL SHAPE STYLE | 1 RECTANGULAR |
PERIPHERAL SHAPE STYLE | 1 ROUND |
CENTER HOLE SHAPE STYLE | 1 ROUND |
OVERALL DIAMETER | 0.625 INCHES NOMINAL |
PROPRIETARY CHARACTERISTICS | PACS |
SURFACE TREATMENT | ZINC OVERALL AND DICHROMATE |
CROSS-SECTIONAL SHAPE STYLE | RECTANGULAR |
HOLE DIAMETER | 0.281 INCHES NOMINAL |
PERIPHERAL SHAPE STYLE | ROUND |
CENTER HOLE SHAPE STYLE | ROUND |
THICKNESS | 0.067 INCHES NOMINAL |
OVERALL DIAMETER | 0.500 INCHES NOMINAL |
III END ITEM IDENTIFICATION | MRAP - COUGAR TOW |
FEATURES PROVIDED | CASEHARDENED |
MATERIAL | STEEL OVERALL |
SURFACE TREATMENT | ZINC AND DICHROMATE OVERALL |
CROSS-SECTIONAL SHAPE STYLE | 1 RECTANGULAR |
PERIPHERAL SHAPE STYLE | 1 ROUND |
CENTER HOLE SHAPE STYLE | 1 ROUND |
OVERALL DIAMETER | 0.625 INCHES NOMINAL |
PROPRIETARY CHARACTERISTICS | PACS |
SURFACE TREATMENT | ZINC OVERALL AND DICHROMATE |
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch ( .8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be . 6 inches ( .15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be . 16 inches ( .4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items. |