| ALKAN | F0554 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| SARGENT AEROSPACE & DEFENSE, LLC | 78062 |
| PILATUS AIRCRAFT LTD | S4080 |
| H. V. MODY, INC. | 0P012 |
| NATIONAL AEROSPACE STANDARDS COMMITTEE AEROSPACE INDUSTRIES ASSOCIATION OF AMERICA INC NOT FOR RFQ OR SOLICITATION USE | 80205 |
| SOCATA | F0086 |
| HOLE DIAMETER | 0.378 INCHES MINIMUM AND 0.388 INCHES MAXIMUM |
| OUTSIDE DIAMETER | 0.687 INCHES NOMINAL |
| RECESS DIAMETER | 0.483 INCHES MINIMUM AND 0.495 INCHES MAXIMUM |
| MATERIAL THICKNESS | 0.078 INCHES NOMINAL |
| III MINIMUM TENSILE STRENGTH | 125000 POUNDS PER SQUARE INCH |
| RECESS ANGLE | 90.0 DEGREES NOMINAL |
| MATERIAL | STEEL COMP 1330 OVERALL OR STEEL COMP 4130 OVERALL |
| MATERIAL DOCUMENT AND CLASSIFICATION | 66 FED STD SINGLE MATERIAL RESPONSE OVERALL |
| SURFACE TREATMENT | CADMIUM OVERALL |
| SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-416,TY 2,CL 3 FED SPEC SINGLE TREATMENT RESPONSE OVERALL |
| STYLE DESIGNATOR | RECESSED |
| WASHER STYLE | 16 |
| HARDNESS RATING | NOT RATED |
| A WASHER OF ANY PERIPHERAL SHAPE HAVING A CENTRALLY LOCATED HOLE. BOTH BEARING SURFACES ARE PARALLEL AND FLAT, BUT ONE OR BOTH OF THE BEARING SURFACES MUST BE BROKEN BY A COUNTERBORE, COUNTERSINK, OR SIMILARLY SHAPED RECESS. THE THICKNESS MUST NOT EXCEED 25 PER CENT OF THE OUTSIDE DIAMETER OR THE LARGEST OUTSIDE DIMENSION. THE MAXIMUM LIMIT OF THE TOLERANCE OR RANGE APPLIED TO THE THICKNESS AND/OR LARGEST OUTSIDE DIMENSION MUST BE USED TO DETERMINE COMPLIANCE. EXCLUDES WASHER, CONCAVE, RETAINER, PACKING, AND THRUST TYPE WASHERS. SEE ALSO SPACER, SLEEVE; AND SPACER, STEPPED. |
