Part Number: BL-6752

(No reviews yet) Write a Review
CONDITION:
NS
BREEZE-EASTERN LLC8484
BREEZE-EASTERN LLC8484
CROSS-SECTIONAL SHAPE STYLERECTANGULAR
HOLE DIAMETER0.190 INCHES MINIMUM AND 0.194 INCHES MAXIMUM
PERIPHERAL SHAPE STYLEROUND
CENTER HOLE SHAPE STYLEROUND
THICKNESS0.052 INCHES MINIMUM AND 0.054 INCHES MAXIMUM
OVERALL DIAMETER0.302 INCHES MINIMUM AND 0.322 INCHES MAXIMUM
MATERIALSTEEL COMP 303 OVERALL
MATERIAL DOCUMENT AND CLASSIFICATIONQQ-S-764 COND A FED SPEC SINGLE MATERIAL RESPONSE OVERALL
SURFACE TREATMENTPASSIVATE OVERALL
SURFACE TREATMENT DOCUMENT AND CLASSIFICATIONMIL-S-5002 MIL SPEC SINGLE TREATMENT RESPONSE OVERALL
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch ( .8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be . 6 inches ( .15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be . 16 inches ( .4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.