Part Number: GTS51-5H

(No reviews yet) Write a Review
CONDITION:
NS
GOODRICH LIMITEDK0131
CROSS-SECTIONAL SHAPE STYLERECTANGULAR
HOLE DIAMETER0.162 INCHES MINIMUM AND 0.167 INCHES MAXIMUM
PERIPHERAL SHAPE STYLEROUND
CENTER HOLE SHAPE STYLEROUND
THICKNESS0.019 INCHES MINIMUM AND 0.021 INCHES MAXIMUM
OVERALL DIAMETER0.245 INCHES MINIMUM AND 0.255 INCHES MAXIMUM
III HEAT TREATMENTAS FABRICATED
MATERIALSTEEL CORROSION RESISTING OVERALL
NONDEFINITIVE SPEC/STD DATAA GRADE
CROSS-SECTIONAL SHAPE STYLERECTANGULAR
HOLE DIAMETER0.162 INCHES MINIMUM AND 0.167 INCHES MAXIMUM
PERIPHERAL SHAPE STYLEROUND
CENTER HOLE SHAPE STYLEROUND
THICKNESS0.019 INCHES MINIMUM AND 0.021 INCHES MAXIMUM
OVERALL DIAMETER0.245 INCHES MINIMUM AND 0.255 INCHES MAXIMUM
III HEAT TREATMENTAS FABRICATED
MATERIALSTEEL CORROSION RESISTING OVERALL
NONDEFINITIVE SPEC/STD DATAA GRADE
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch ( .8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be . 6 inches ( .15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be . 16 inches ( .4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.