RESISTOR,FIXED,WIRE,RESISTOR,FIXED,WIRE,
| MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | 81349 |
| MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | 81349 |
| MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | 81349 |
| MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | 81349 |
| ELECTRICAL RESISTANCE | 0.464 OHMS |
| RESISTANCE TOLERANCE IN PERCENT | -1.000 TO 1.000 |
| AMBIENT TEMP IN DEG CELSIUS AT FULL RATED POWER | 25 |
| AMBIENT TEMP IN DEG CELSIUS AT ZERO PERCENT RATED POWER | 275 |
| TEMP RANGE OF TEMP COEFFICIENT IN DEG CELSIUS | -55.0 TO 275.0 |
| INCLOSURE METHOD | ENCAPSULATED |
| TERMINAL TYPE | WIRE LEAD |
| RELIABILITY INDICATOR | ESTABLISHED |
| RELIABILITY FAILURE RATE LEVEL IN PERCENT | 0.01 |
| TERMINAL LENGTH | 1.500 INCHES MINIMUM |
| BODY DIAMETER | 0.065 INCHES MINIMUM AND 0.105 INCHES MAXIMUM |
| BODY LENGTH | 0.219 INCHES MINIMUM AND 0.281 INCHES MAXIMUM |
| POWER DISSIPATION RATING IN WATTS | 1.000 FREE AIR |
| CUBIC MEASURE | 0.002 CUBIC INCHES |
| SPECIAL FEATURES | TEMP COEF NOT TO EXCEED PLUS 650 PPM |
| III UNPACKAGED UNIT WEIGHT | 0.35 GRAMS |
| STYLE DESIGNATOR | AXIAL TERMINAL EACH END |
| TEST DATA DOCUMENT | 81349-MIL-R-39007 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| SPECIFICATION/STANDARD DATA | 81349-MIL-R-39007/9 GOVERNMENT SPECIFICATION |
| TERMINAL TYPE AND QUANTITY | 24 PRINTED CIRCUIT |
| INC 374 3 REINSTATED ON 1 3 3~A resistor whose ohmic value cannot be adjusted or varied. The resistance element consists of high resistance wire (or ribbon) either wound on an insulated form or constructed so as to be self-supporting. The item must have inherent characteristics of inducing self-inductance. Opposition to current flow is an inherent property of the resistance wire and is manifested by the heat dissipation in the resistor. Excludes SUPPRESSOR, IGNITION INTERFERENCE. See also RESISTOR (1), FIXED, WIRE WOUND, NONINDUCTIVE. |
