RESISTOR,FIXED,FILM,
| MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | 81349 |
| MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | 81349 |
| MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | 81349 |
| MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | 81349 |
| TEMP COEFFICIENT OF RESISTANCE IN PPM PER DEG CELSIUS | -50.0 TO 50.0 |
| ELECTRICAL RESISTANCE | 2.940 KILOHMS |
| RESISTANCE TOLERANCE IN PERCENT | -1.000 TO 1.000 |
| AMBIENT TEMP IN DEG CELSIUS AT FULL RATED POWER | 125 |
| AMBIENT TEMP IN DEG CELSIUS AT ZERO PERCENT RATED POWER | 175 |
| TEMP RANGE OF TEMP COEFFICIENT IN DEG CELSIUS | -55.0 TO 175.0 |
| INCLOSURE METHOD | ENCAPSULATED |
| TERMINAL TYPE | WIRE LEAD |
| MIL-STD-1276 WIRE LEAD TYPE DESIGNATOR | C |
| RELIABILITY INDICATOR | ESTABLISHED |
| RELIABILITY FAILURE RATE LEVEL IN PERCENT | 0.001 |
| TERMINAL LENGTH | 0.984 INCHES MINIMUM AND 1.516 INCHES MAXIMUM |
| BODY DIAMETER | 0.050 INCHES MINIMUM AND 0.080 INCHES MAXIMUM |
| BODY LENGTH | 0.160 INCHES MINIMUM AND 0.200 INCHES MAXIMUM |
| POWER DISSIPATION RATING IN WATTS | 0.050 FREE AIR |
| UNPACKAGED UNIT WEIGHT | 0.11 GRAMS |
| STYLE DESIGNATOR | AXIAL TERMINAL EACH END |
| TEST DATA DOCUMENT | 81349-MIL-R-55182 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| SPECIFICATION/STANDARD DATA | 81349-MIL-R-55182/7 GOVERNMENT SPECIFICATION |
| A resistor whose ohmic value cannot be adjusted or varied. The resistance element consists of either a thin layer of conductive material, containing either binders or insulating materials, deposited on an insulated form; or an alloy of metal and ceramic materials, usually fused to an insulated form. Opposition to the flow of current is an inherent property of the materials used and is manifest by the heat dissipation in the resistor. See also ATTENUATOR, FIXED and RESISTOR, FIXED, COMPOSITION. Excludes carbon composition type resistors. |
