Part Number: MS14183L-C6

Alternate Part Number:
5310-01-379-7029

(No reviews yet) Write a Review
CONDITION:
NS
WASHER, COUNTERSUNK,
NATIONAL AEROSPACE STANDARDS COMMITTEE AEROSPACE INDUSTRIES ASSOCIATION OF AMERICA INC NOT FOR RFQ OR SOLICITATION USE80205
MILITARY STANDARDS PROMULGATED BY MILITARY DEPARTMENTS UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M96906
CROSS-SECTIONAL SHAPE STYLERECTANGULAR
HOLE DIAMETER0.375 INCHES MINIMUM AND 0.380 INCHES MAXIMUM
PERIPHERAL SHAPE STYLEROUND
CENTER HOLE SHAPE STYLEROUND
THICKNESS0.071 INCHES MINIMUM AND 0.085 INCHES MAXIMUM
OVERALL DIAMETER0.691 INCHES MINIMUM AND 0.791 INCHES MAXIMUM
INSIDE LEFT CORNER CHAMFER ANGLE45.0 DEGREES NOMINAL
INSIDE RIGHT CORNER CHAMFER ANGLE45.0 DEGREES NOMINAL
MATERIALNICKEL ALLOY 718 OVERALL
SPECIAL FEATURES1/4 W; CARBON
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch ( .8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be . 6 inches ( .15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be . 16 inches ( .4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.