| BOURNS INSTRUMENTS INC | 80294 |
| SECTION QUANTITY | 1 |
| BODY STYLE | RECTANGULAR W/MOUNTING HOLES/SLOTS |
| RELIABILITY INDICATOR | NOT ESTABLISHED |
| III OVERALL LENGTH | 1.313 INCHES NOMINAL |
| TERMINAL LENGTH | 0.188 INCHES NOMINAL |
| III OVERALL HEIGHT | 0.501 INCHES NOMINAL |
| III OVERALL WIDTH | 0.280 INCHES NOMINAL |
| MOUNTING HOLE DIAMETER | 0.086 INCHES MINIMUM |
| SHAFT DIAMETER | 0.125 INCHES NOMINAL |
| SHAFT LENGTH | 0.063 INCHES NOMINAL |
| BODY LENGTH | 1.250 INCHES NOMINAL |
| BODY WIDTH | 0.280 INCHES NOMINAL |
| BODY HEIGHT | 0.313 INCHES NOMINAL |
| SHAFT STYLE | ROUND, SLOTTED |
| ACTUATOR TYPE | SINGLE SHAFT |
| EFFECTIVE ELECTRICAL ROTATION IN DEG ANGULAR ROTATION | 9000.0 NOMINAL |
| CENTER TO CENTER DISTANCE BETWEEN TERMINALS | 0.688 INCHES NOMINAL |
| LATERAL DISTANCE BETWEEN MOUNTING HOLE CENTERS | 1.000 INCHES NOMINAL |
| MOUNTING FACILITY QUANTITY | 2 |
| TERMINAL LOCATION | LOWER ADJACENT SIDE TWO ROWS |
| MOUNTING METHOD | UNTHREADED HOLE |
| CENTER TO CENTER DISTANCE BETWEEN TERMINAL ROWS | 0.094 INCHES NOMINAL |
| ELECTRICAL RESISTANCE PER SECTION | 50.000 OHMS SINGLE SECTION |
| ROTARY ACTUATOR TRAVEL IN ANGULAR DEG | 9000.0 NOMINAL |
| CENTER TO CENTER DISTANCE BETWEEN CENTER TERMINAL AND OUTSIDE TERMINAL | 0.328 INCHES NOMINAL |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT ZERO PERCENT RATED POWER | 125.0 SINGLE SECTION |
| TEMP COEFFICIENT OF RESISTANCE PER SECTION IN PPM PER DEG CELSIUS | -100.0 TO 100.0 SINGLE SECTION |
| POWER DISSIPATION RATING PER SECTION IN WATTS | 0.5 FREE AIR SINGLE SECTION |
| RESISTANCE TOLERANCE PER SECTION IN PERCENT | -10.0 TO 10.0 SINGLE SECTION |
| ACTUATOR TRAVEL CONTROL FEATURE | CLUTCH |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER | 70.0 SINGLE SECTION |
| TERMINAL TYPE AND QUANTITY | 3 TAB, SOLDER LUG |
| STYLE DESIGNATOR | 153 KEY |
| A resistor in which a sliding or rolling contact moves over an exposed area of the resistive element to change the ohmic value of the output. The functional tolerance (linearity), if given, of the output is greater than plus of minus 1 percent on linear outputs. Specified outputs such as sine, cosine, tangent, etc., shall be considered to be precision. For items having manually positioned taps designed to be set and fixed prior to use, see RESISTOR, ADJUSTABLE. For items with step by step variation, see RHEOSTAT and RESISTOR, STEP BY STEP. For tandem-mounted items designed to function together as an attenuator (and rated accordingly), see ATTENUATOR, VARIABLE. Excludes RESISTOR (1), VARIABLE, NONWIRE WOUND, NONPRECISION; RESISTOR (1), VARIABLE, NONWIRE WOUND, PRECISION; and RESISTOR (1), VARIABLE, WIRE WOUND, PRECISION. |
